The requirement of 200º C might be met by silicone-rubber insulated
wire, Belden makes HV silicone-rubber insulated wire for auto
ignition systems and test-leads. .
On Apr 10, 2004, at 8:56 PM, AA6DX wrote:
Don't know about these days, but used to use TV high-voltage lead ...
available in bulk at TV/electronic wholesale parts stores. Coax works
swell, too .. I used to use RG-8 with over 5500 volts (4-1000
amplifiers) --- never had a problem.
73, Mark AA6DX
----- Original Message -----
From: "Frank Goenninger" <frank_goenninger@t-online.de>
To: <amps@contesting.com>
Sent: Saturday, April 10, 2004 12:45 PM
Subject: [Amps] HV cable for abt 200 degrees celsius?
Hi all:
Yet another question for building this GU-84b based amp:
What cables would you suggest (and where to get that in Europe) for
the
High Voltage (abt 4 kV) connections within the amp and between the amp
and the PS?
Which insulation to take? PE, VPE?
Thx es 73 de Frank DG1SBG
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Rich Measures, AG6K, 805.386.3734. www.somis.org/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|