what would be the parameters for the toroid , for say , 8 or 10 amps ,
other than the size to accomodate the required wire size.???
carl / kz5ca
----- Original Message -----
From: "Phil Clements" <philk5pc@tyler.net>
To: <jsb@digistar.com>; "R.Measures" <r@somis.org>
Cc: <amps@contesting.com>
Sent: Friday, September 17, 2004 11:55 AM
Subject: Re: [AMPS] floating a filament transformer
> > I have been reading with interest about the filament chokes for
> > 3-500Z,
> > etc. In the photos I've seen of projects the filament choke appears
> > to be
> > bare wires around the ferrite rod. Am I seeing this correctly? How
> > does
> > this not short out and thereby not provide current to heat the
> > filaments?
> > Or is this wire typically coated with some kind of insulating
> > material.
> >
>
> The wire is insulated with an enamel coating.
>
> There is nothing magic about the ferrite rod. A torroid will also
> work fine.
> Henry uses torroids on some of its models where space under the
> chassis is at a premium.
>
> (((73)))
> Phil, K5PC
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|