Amps
[Top] [All Lists]

Re: [Amps] Advice on instruments for ham use

To: <G3rzp@aol.com>, <dezrat1242@ispwest.com>, <amps@contesting.com>
Subject: Re: [Amps] Advice on instruments for ham use
From: "Gary Smith" <wa6fgi@sbcglobal.net>
Reply-to: Gary Smith <wa6fgi@sbcglobal.net>
Date: Fri, 26 Nov 2004 16:25:19 -0800
List-post: <mailto:amps@contesting.com>
Peter & all: thank you for the info, and yes, the primary use of the `scope 
would be for hf audio/signal observation.
73
Gary
WA6FGI

snip


  ----- Original Message ----- 
  From: G3rzp@aol.com 
  To: wa6fgi@sbcglobal.net ; dezrat1242@ispwest.com ; amps@contesting.com 
  Sent: Friday, November 26, 2004 1:20 PM
  Subject: Re: [Amps] Advice on instruments for ham use


  In a message dated 26/11/2004 19:32:47 GMT Standard Time, 
wa6fgi@sbcglobal.net writes:
    What would be a good (cheap) analog  (or digital ) scope to use for the 
sole purpose of observing my transmitted signal?
    And being I have zero experience with a scope, what would be the easiest 
method of hooking it up? 

  What frequency? In the HF band, the easy way is a T piece and and a short 
coax to the scope. If you're running the full gallon, you'll need an 
attenuator, and that needs to be high impedance - a small series capacitor. A 
50 ohm attenuator will not do.

  If you want to be 'posh', use a directional coupler. Take an aluminium box, 
fir a pair of SO239 or N type or whatever. Cut a strip of metallised PC Board 
about 0.18 inch wide for fibreglass 1/16 inch thick, and glue it (superglue) so 
that reaches pretty well between the two sockets: connect each end to the 
sockets.

  Now cut another strip, and glue it parallel to the first, with about 1/8 inch 
separation. Connect one end to a BNC socket, and the other through a 47 ohm 
metal film resistor to ground. Connect the tx to one end of the through line 
and the antenna to the other. Connect the scope to the BNC. Fire up to 100w 
atts, measure the volts on the scope. reverse the antenna and tx connections 
and measure again. Connect so you get maximum on the scope.

  Now you have a directional coupler, used 30 or 40 years ago for SWR 
measurements. The coupled signal increases at 6dB per octave - i.e., going from 
7 to 14 MHz for the same power, you'll get twice the voltage, but this 
shouldn't be a problem. If it is, put in  a series R, and parallel C 
combination to give an inverse slope.

  There was a book in France called ' La Radio - c'est plus simple' (Radio - 
it's very easy)

  Sometimes it's so. A French review of Scroggie's book  'Second Thoughts on 
Radio Theory@ (highly recommended, by the way) suggested that perhaps it should 
be called 'La radio - ca n'est pas si simple' (Radio isn't that easy). But in 
this case, it is.

  73

  Peter G3RZP
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>