Amps
[Top] [All Lists]

Re: [Amps] Re: AMPS Link coupling

To: <amps@contesting.com>
Subject: Re: [Amps] Re: AMPS Link coupling
From: "Steve Thompson" <g8gsq@ic24.net>
Date: Mon, 10 Jan 2005 08:37:21 -0000
List-post: <mailto:amps@contesting.com>
Ian White, G3SEK wrote:
> G3RZP wrote:
>>
>  >>Rich wrote
>  >>There is  no antenna matching network that has a lower Q than an
> L->>network.
>  >
>>
>> This is not correct. A parallel tuned circuit with a coupling  link,
>> loaded by a high impedance antenna can have its LC ratio determined
>> such as to control the value of Q. It is possible that self capacity
>> of the coil could be a limit in some cases.
>>
> Ignoring the unloaded Qs of the individual components from which a
> network can be constructed...
>
> The minimum possible *loaded* Q that is required to transform between
> two resistances R2>R1, using any possible circuit, is sqrt(R2/R1 -1).
>
> The L-network has exactly that value of loaded Q, so it is correct
> that no other network can go lower (at least for resistive loads; not
> sure about impedances in general).
Sketching it on a Smith chart, a quarter wave transmission line transformer
follows a locus with a lower peak Ql. Does that count, even if it's of
limited practical use?

Steve



-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.6.9 - Release Date: 06/01/05

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>