Japerlick@aol.com wrote:
>Sure, you could use Glycol, but why would you want to?
>
>Glycol has very high "Enthalpy" which means it can hold a lot of heat per
>unit volume.
>
Which is what you want for a good coolant!! You want a small amount of
the liquid to be able to absorb a lot of heat, with the minimum change
in temperature.
However, I think water has one of the highest specific heat capacities,
which is why it is a good coolant.
>It is also really poinsonious.
>
I don't think there is such a chemical as 'glycol', but there are many
'glycols'.
http://www.thermalfluidsinc.biz/generic2.html
has a coolant based on ethylene glycol (I can't be bothered to look at
their data, as it is in Microsoft Word format). but ethylene glycol is
dangerous as you say
But 'Thermasafe'
http://www.thermalfluidsinc.biz/generic3.html
is based on propylene glycol, and is said to be okay if there is
accidental contact with food.
But I doubt any have the specific heat capacity of water, which why it
is one of the best liquids for removing heat,
> There are LOTS of other good fluids
>one could use, but why? Water is great!
>
It has its downsides, as have been referred too.
>Cray Research used Flourinert, made by 3M, in their computers. The entire
>computer, circuit boards and all, were inside a flourinert solution which was
>continously circulated to draw heat out of the ECL logic.
>
Just thought I'd mention that if anyone wants to use a Cray
supercomputer for free, you can get an account here
http://www.cray-cyber.org/general/start.php
Just don't expect much performance, as the machines are very old.
It sure checks the portability of your code, as sizeof(short)=8 !!!
A paper describing the original Cray and its cooling can be found there
too.
--
Dr. David Kirkby,
G8WRB
Please check out http://www.g8wrb.org/
of if you live in Essex http://www.southminster-branch-line.org.uk/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|