On Sep 20, 2005, at 11:25 PM, robert briggs wrote:
> This one may have been asked before.Over the past few years I have
> constructed a few amplifiers using pairs of 4CX250/350B tubes in Super
> Cathode Driven Mode,The Screen Grid grounded and the Control Grid tied
> to the Cathode.The amplifier's have been quite reliable and I havn't
> worn a tube out yet despite some quite hard use from time to time.
> I got the idea origionally from an article by Orr and Sayer in QST
> July 1967.
> I am wondering if this method could be applied to the 4CX1500B.
Yes, provided you need an amplification of c. 5x.
> I have a few new tube's and a socket or two but can't be bothered with
> Grid Bias and Screen voltages and all the extra circutry involved.
> I would be interested in some good technical opinion's.
> Regards all from Bob VK3ZL..
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|