If it's like a TL-922, the same amount of 120V current pass through the fuses
regardless of how it's strapped. It's just that on 240, the 120 phases are
split. What's so hard to understand about that? From the source, it draws all
the current from a single 120 wire, instead of two 120V wires carrying half the
current. Input power is the same -- no brain surgery here.
Joe, N3JI
"Lon W. Cottingham" <k5jv@kingwoodcable.com> wrote:
Greetings to all,
<SNIP>
Here is a question for the group. In the SB-220 linear (as well as
many others) why are the circuit breakers (fuses) not changed when switching
from 110 VAC to 220 VAC operation?
...
73 de K5JV
Lon W. Cottingham
1110 Golden Bear Ln.
Kingwood, TX 77339
281-358-4207
281-358-4234 FAX
281-795-1335 CELL
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---------------------------------
Yahoo! Music Unlimited - Access over 1 million songs. Try it free.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|