On Feb 6, 2006, at 7:36 AM, StephenTetorka@cs.com wrote:
> Hi all:
>
> Might it be possible to apply a high-pass filter to eliminate the 60
> Hertz ac
> power supply noise from getting into my filaments?
>
> Also..it is my understand that using a DC filament voltage works just
> as well
> as the AC...correct?
For heater-type cathodes or filament-type cathodes?
>
> Regards,
> Steve
> WA2TAK
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|