I know the copper tubing is a bit easier but home depot only had the 1/4"
and that is a bit too big for my application, I'm trying to size things down
the dowel with a hole sounds like the way then put it on a lathe..
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of Partain, Chuck
Sent: Tuesday, April 04, 2006 1:07 PM
To: amps@contesting.com
Subject: [Amps] rolling your own
Has anyone found an EASIER way to roll #4 solid copper wire up for an inductor?
this stuff is STIFF!!!!!!!!!!
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|