Hi again, everybody --
Thanks to all who answered. Now if I can just get my hands on the amp, I'll
give them a try (The current owner just left town for 2 weeks).
Here is another problem for all the gurus out there. I also have a SB-200
with most of the Harbach mods.(HVPS, Soft Start, Soft Key) It also has
AG6K's Parasitic suppressor. Whenever I key it using my 756PRO in RTTY
mode, the output power is VERY LOW (50-80 watts or so). Plate current for
both tubes is running about 200-250 ma, and grid current pegs negatively.
The tube plates turn a brilliant red-orange, and the heat above the tube
compartment goes WAY UP. Every now and then, the power out jumps to 700 or
so watts, but only for a second or two. The plates don't have time to cool
off before the problem comes right back.
I have new Taylor 572B tubes (still in the box, in case I need them).
What could be causing this problem? Would a shorted or open blocking cap or
a tune or load control do this? I suspect the solution to this problem is
easy, but so far it has eluded me.
Only a week or so to the CA QSO Party. I'd sure like to use it then. . . Any
ideas, anybody???
73,
Bob Green W6BBL
w6bbl@charter.net
This e-mail was scanned by the latest update to Norton Anti-Virus 2006, and
is guaranteed 100% virus free.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|