I have my Dad's MLA-2500 in my shack for what I suspect is a filter
capacitor replacement job. It hadn't been operated in a long time and
Dad wanted me to check everything out (he's had health problems). I
was tuning it up and all seemed well until I heard a soft pfft,
smelled a Bad Smell, and heard the PS hum loudly, clearly drawing
lots of current.
Removing the drive didn't help and neither did putting it in
standby. This was all discovered rather quickly, I might add, and
the fuse didn't blow. After letting everything sit a minute, I
clearly still had a problem when I turned the power back on.
I've never smelled a blown electrolytic, but I suspected that was the
problem. A careful inspection shows that one of them has a small hole
(less than 1 mm) in the seal at the bottom and smells faintly of what
I remember. I have new capacitors. These are the original filter
capacitors and they're pop-riveted in. Before I drill out the rivets,
does it sound like I've reasonably diagnosed the problem?
Kim Elmore, N5OP
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|