That would be ideal but not necessary. Stainless steel is just fine,
stronger, and more readily available. Avoid aluminum to copper and
aluminum to brass contact. Good luck with your project. 73, Tim, W2UI
Steve Flood wrote:
> If I'm building up an amp (the RF compartment particularly) with aluminum
> sheet and angle stock, should I be using aluminum bolts/nuts/washers to avoid
> galvanic corrosion?
>
> Steve, KK7UV
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|