I remember reading a letter from Kenwood about 20 years ago that stated that
their SS PA stages were designed to operate into 25-75 Ohm loads since 50
Ohm cable was not a world wide standard.
Ive been operating my TS-940's ( and TS-930's before that) into 75 Ohm loads
since the late 80's with no difficulty and no power foldback. I do not use
an antenna tuner, built in or external.
Carl
KM1H
----- Original Message -----
From: "David Cutter" <d.cutter@ntlworld.com>
To: <amps@contesting.com>
Sent: Sunday, March 09, 2008 8:18 AM
Subject: Re: [Amps] Transceiver Output Impedance
> One of these days I will try the following experiment.
>
> I will MAKE a rf signal generator and add resistance in series with it to
> a
> load of 50ohms and stop adding resistance when the load voltage is half
> the
> open circuit voltage. I will then assume this signal generator has an
> output impedance of 50ohms. OR I will take a "known" 50ohm signal
> generator
> and test it for open and loaded output voltage.
>
> Then I will take say an ICE bandpass filter that has been tested on
> someone
> else's high grade test rig and characterise it on my signal generator with
> a
> 50ohm load.
>
> Then I will do the same with a transmitter and see if the results are the
> same. If they are, I will assume that my transmitter is also 50ohm
> "output
> impedance."
>
> Then I will be more sure which side of the fence to drop.
>
> I suspect the output impedance of a broad band amplifer with L-C low pass
> filters and transformer matching stages (possibly even feedback,
> feedforward, stabilisation, etc ) does transmission line stuff and is not
> just like a resistor in series with a zero source (Thevenin).
>
> The heavy weights have been arguing about this for quite a while and I've
> seen magazine articles on the subject.
>
> David
> G3UNA
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|