What frequency does it operate at? RF, AF ?
If ferrites dont fix it the problem it is likely overload at the input
and a filter may have to be added. That could be simple to complicated.
Carl
KM1H
----- Original Message -----
From: "Francis Sanita" <fsanita@cfl.rr.com>
To: "AMPS" <amps@contesting.com>
Sent: Wednesday, February 04, 2009 7:08 AM
Subject: [Amps] RF ?
>I have a question I would like to put out for discussion.
>
> After using my SB 200 I notice that my Genie garage door opener will
> not work. The opener has a control board that searches for new
> frequency codes as a security feature. The control board apparently
> shuts down and I must unplug the opener and re plug to reset it.
>
> I have not eliminated this issue to any particular band and no other
> equipment in my shack affects the garage door opener ( not even my
> 30L-1). The door issue does not occur when the amp is not used and can
> run smoothly until the amp is put into use again so I feel the amp is
> the cause.
>
> Before I start tearing things apart - has anyone experienced similar
> issues or have suggestions as to how to proceed.
>
> Thank you.
>
> Frank Sanita AA4FS
> Palm Coast, Fl 32164
> fsanita@cfl.rr.com
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|