I had the same problem with my Genie Accelerator garage door opener and
Genie was not able to help me. I finally solved the problem completely by
putting a .01 disk cap between the 2 terminals that connect to the actuator
switch that is by your door into the house. Since one of these terminals is
ground, there is no need to bypass both of them. No problems since.
Bob W6TR
----- Original Message -----
From: "Francis Sanita" <fsanita@cfl.rr.com>
To: "AMPS" <amps@contesting.com>
Sent: Wednesday, February 04, 2009 12:08 PM
Subject: [Amps] RF ?
>I have a question I would like to put out for discussion.
>
> After using my SB 200 I notice that my Genie garage door opener will
> not work. The opener has a control board that searches for new
> frequency codes as a security feature. The control board apparently
> shuts down and I must unplug the opener and re plug to reset it.
>
> I have not eliminated this issue to any particular band and no other
> equipment in my shack affects the garage door opener ( not even my
> 30L-1). The door issue does not occur when the amp is not used and can
> run smoothly until the amp is put into use again so I feel the amp is
> the cause.
>
> Before I start tearing things apart - has anyone experienced similar
> issues or have suggestions as to how to proceed.
>
> Thank you.
>
> Frank Sanita AA4FS
> Palm Coast, Fl 32164
> fsanita@cfl.rr.com
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|