What I can say for sure is that the amplifier I have puts out about 950
Watts at 2500 VDC on the plate and uses air capacitors. I never had arcing
or burnouts!
The idea put forth by Peter is wonderful. With his permission I shall adopt
it for my future projects.
Alex
SunWolf
"Jesus, come get your kids, they're tearing up my Mother's backyard!"
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Peter Voelpel
Sent: Thursday, February 05, 2009 6:54 PM
To: 'Amps'
Subject: Re: [Amps] Plate Choke Values
As you are already going to use vacuum variables you can put the choke after
the roller inductor to the 50 ohm side.
The anode variable and roller must withstand twice your anode voltage and
the blocking capacitor needs much more capacity.
But then your choke can be become much smaller, 50-90µH are sufficient and
that can be wound without any in band resonance.
73
Peter
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Alton McConnell
I have not settled on the oputput network yet either. I have a large roller
inductor and two vacuum variables for the ouput (tank) network and I am
quite aware of the plate choke issue. At least one person has reported
using relay switched plate chokes to make sure they can use their amps on
all the bands.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
No virus found in this incoming message.
Checked by AVG i www.avg.com
Version: 8.0.233 / Virus Database: 270.10.18/1935 i Release Date: 02/04/09
16:35:00
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|