But what do you do if you do not understand Morse Code?
Mike
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of k6xx@juno.com
Use your normal CW keyer. Place the paddle next to something so it sends a
continuous stream of dots. Nice 50% duty cycle and adjustable rate. No RF
involved.
Worked for me when I did a similar measurement with vacuum relays...
73 de Bob, K6XX
Date: Mon, 25 May 2009 12:25:08 -0600
From: "Steve Flood" <kk7uv@bresnan.net>
Subject: Re: [Amps] using a scope to time relays
To: <amps@contesting.com>
Message-ID: <88B4B5EE595F49A597E056A036D66DAC@STEVES>
Content-Type: text/plain; format=flowed; charset="iso-8859-1";
reply-type=original
>From: "Mike Schelly"
> This might help...
>
> http://w8ji.com/relay_timing.htm
>
> http://w8ji.com/relay.htm
>
Thanks Mike. That is exactly the relay timing circuit I am using. Now I
just need to check the timing and adjust as needed.
His method for measuring the time delay appearts to use a little circuit to
key the exciter. I would rather make sure my relays are properly timed
before I start making any RF. Or am I misinterpreting his setup???
Steve
------------------------------
Message: 11
Date: Mon, 25 May 2009 14:56:37 -0300
From: "Carl" <km1h@jeremy.mv.com>
Subject: [Amps] 813 bias
To: <amps@contesting.com>
Message-ID: <015f01c9dd62$282cfbe0$6700a8c0@DAVES>
Content-Type: text/plain; charset="iso-8859-1"
The full spec sheet will also give you typical operating values for Class
AB, B, and C. Its sometimes less stressful than digging over ideal curves
which need tweaking anyway in the real world.
http://frank.yueksel.org/sheets/079/8/813.pdf
Carl
KM1H
------------------------------
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
End of Amps Digest, Vol 77, Issue 32
************************************
____________________________________________________________
Durable and cost effective steel buildings. Click for huge discounts.
http://thirdpartyoffers.juno.com/TGL2131/fc/BLSrjnsKkXzTEnSUw400TI8FthcQJvBS
Xnm7DA8TKJzrkBkxeaGwwAvztQU/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.339 / Virus Database: 270.12.37/2131 - Release Date: 05/25/09
08:16:00
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|