When switching from 120v to 240v the white wire becomes a hot wire, so
simply make the wiring change in the amp to 240, then connect the white and
black from the original cord to the 2 hots to the house supply line. Take a
separate wire and ground the chassis to a water pipe, this way you do not
need to change the cord. If you want to go through changing the cord, use a 3
wire cord and ground the green to the chassis. You DO NOT use 4 wires in
this case as on 240v you do not need a neutral.
In a message dated 8/27/2009 8:32:45 P.M. Pacific Daylight Time,
patriot121@msn.com writes:
Iv come to a misunderstanding about 240V hookup. Is the neutral supposed
to be connected to the case and the ground too, from a 4wire drop?? I cant
find a description of the 240V hookup in the HL-2K manual when pertaining to
the neutral and ground.
If any one has a HL-2K from Tokyo HyPower and running on 220V/240V how
exactly did you do with these before mentioned connections ...
KC7NOA
_________________________________________________________________
Windows Live: Make it easier for your friends to see what you’re up to on
Facebook.
http://windowslive.com/Campaign/SocialNetworking?ocid=PID23285::T:WLMTAGL:ON
:WL:en-US:SI_SB_facebook:082009
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|