Amps
[Top] [All Lists]

Re: [Amps] SB-220 bias question

To: df3kv@t-online.de, amps@contesting.com
Subject: Re: [Amps] SB-220 bias question
From: gudguyham@aol.com
Date: Sat, 29 Aug 2009 13:17:26 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
NO WAY


To do so you have to modify the pi-net, as the output impedance of the tube
will be much higher

73
Peter




-----Original Message-----
From: DF3KV <df3kv@t-online.de>
To: amps@contesting.com
Sent: Sat, Aug 29, 2009 12:56 pm
Subject: Re: [Amps] SB-220 bias question



To do so you have to modify the pi-net, as the output impedance of the tube
will be much higher

73
Peter

-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On 

My whole point is to run the tubes at higher plate voltage with less plarte
and grid current for the same power output

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>