Trying to decipher Orr at times is a task.
Is he trying to say that the tube absorbs 90% and feed thru 10%?
If so wouldnt loading for optimum grid current in the spec sheet accomplish
that? Sort of by default?
Ive never read that version, which edition were you reading?
Carl
KM1H
----- Original Message -----
From: <TexasRF@aol.com>
To: <amps@contesting.com>
Sent: Tuesday, March 30, 2010 7:13 PM
Subject: [Amps] gg feed through power
> After more reading in the Orr book, I discovered a discussion of feed
> through power in a cathode driven amplifier.
>
> We have all heard about the drive power adding to the output power. Orr
> says, and I am paraphrasing here, that a PORTION of the drive power is
> added
> to the output power. He goes on to say that the greater the ratio of
> drive
> power to the feed through power, the better the imd performance. He
> further
> suggested that the optimum feed through power for best imd performance is
> about 10%.
>
> Heck, 10% of a 100w drive level is insignificant and might as well be
> ignored.
>
> He did not describe how one goes about attaining the 10% feed through
> level
> and I suspect there is no control of this. Perhaps you get what you get
> with a given tube?
>
> He also wrote about the improved imd performance due to the heavy negative
> feed back inherent in cathode driven amplifiers compared to grid driven;
> often in the 10 to 15 dB range of improvement.
>
> We have always heard this to be so; at least that old saying is correct.
>
> 73,
> Gerald K5GW
>
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|