ORIGINAL MESSAGE:
On Tue, 26 Oct 2010 21:02:15 -0400, "Carl" <km1h@jeremy.mv.com> wrote:
>Straight from the Micrometals spec sheets and then some testing.
REPLY:
Carl: In your original post you said "A 6 mix iron powder is good for
6-10M" and you quote Micrometals data sheet. But according to the
Micrometals data sheet at http://www.micrometals.com/materialchart.html
it is good for 3-40 MHz, essentially the same as Palomar mix #6.
Are you saying your testing shows Micrometals is wrong and it is only
good from 28-54 MHz? Have you notified them of their error? What was
their response?
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|