Amps
[Top] [All Lists]

[Amps] Airflow meter (was: Alpha vs Henry)

To: amps@contesting.com
Subject: [Amps] Airflow meter (was: Alpha vs Henry)
From: Angel Vilaseca <avilaseca@bluewin.ch>
Date: Wed, 13 Apr 2011 13:25:23 +0200
List-post: <amps@contesting.com">mailto:amps@contesting.com>
An accurate way to measure airflow is to use a peak airflow meter. See 
picture here:

http://en.wikipedia.org/wiki/File:Peak_flow_meter_vert.jpg

This is a low-cost device used by persons with asthma to self-monitor 
their disease. Widely available worldwide.

73 de

Angel Vilaseca HB9SLV

Ian White GM3SEK a écrit :
> Roger (sub1) wrote:
>
>   
>> One other point, I've seen the question raised about how much pressure 
>> was a fan generating.  For a given tube and existing system you can 
>> treat air flow and pressure the same as voltage and current. IF you are 
>> getting the required air flow you MUST have the required air pressure. 
>> Insufficient pressure and you will have insufficient flow.  Get the 
>> proper flow and you will have the proper pressure.
>>
>> IF the radiator is plugged or partially clogged you will have high 
>> pressure and low flow. But again, it the flow if proper then so is the 
>> pressure.
>>
>>     
>
> Air flow rate is what really matters in cooling, and all data sheets for 
> air-cooled tubes will state the minimum volume flow rate required. 
> Pressure drop is only an indirect way of measuring the volume flow 
> rate... and actually a very poor way.
>
> Pressure drop measurements in real amplifiers are very prone to errors, 
> because the reading will depend critically on the orientation of the 
> manometer pickup tubes relative to the air flow. We have no idea what 
> the tube manufacturers did to minimize those errors... or even if they 
> were aware of them. Because of all these problems, pressure drop is 
> probably the wrong thing for us amateurs to measure.
>
> It's actually MUCH easier to measure the volume flow rate directly. No 
> elaborate equipment is needed - simply time how long it takes for the 
> outlet air to fully inflate a large, lightweight plastic bag. With a 
> little care you can measure the volume flow rate within about 10%, which 
> is far more accurate than a pressure measurement.
>
> The original idea came from George Daughters K6GT, and details are right 
> here in the AMPS archives:
> <http://lists.contesting.com/archives//html/Amps/1998-03/msg00172.html>
>
>
>
>   

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>