A small end mill or appropriate Dremel bit makes a nice clean round spot for
the hardware to land
Paul K0UYA
----- Original Message -----
From: "alexeban" <alexeban@gmail.com>
To: "'Robert Briggs'" <vk3zl@bigpond.com>; <amps@contesting.com>
Sent: Wednesday, October 19, 2011 7:29 AM
Subject: Re: [Amps] Anodised aluminum
> Why remove it?
> Black is beautiful!
> Just make sure to clean it around the assembly holes. Anodize is an
> insulator, being an oxide.
> You can even engrave on it all the markings.
> Alex
> 4Z5KS
>
> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
> Behalf Of Robert Briggs
> Sent: Monday, October 17, 2011 12:54 PM
> To: amps@contesting.com
> Subject: [Amps] Anodised aluminum
>
>
>
> Hi all...I have just aquired a quantity of 2mm anodised aluminum sheet,,
> I am wondering if I remove the anodising from all contact surfaces if I
> can use this stock for rf deck cases...
>
> Cheers all....Bob..VK3ZL..
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|