To: | amps@contesting.com |
---|---|
Subject: | Re: [Amps] every db lost re Tubes vs. Solid State |
From: | Jim Brown <jim@audiosystemsgroup.com> |
Reply-to: | jim@audiosystemsgroup.com |
Date: | Mon, 30 Apr 2012 18:31:37 -0700 |
List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
On 4/30/2012 5:57 PM, Larry Benko wrote: > If a connector was lossless but was of an impedance different than the > line there would be mismatch loss with no heating. Mike got it right the first time. The length of a PL259 and mating connector is quite small as a fraction of a wavelength below 500 MHz. The so-called mis-match losses are pretty much fictional, and won't show up in a careful measurement by substitution, and if it doesn't show up in such a measurement it isn't real. 73, Jim K9YC _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [Amps] every db lost re Tubes vs. Solid State, Larry Benko |
---|---|
Next by Date: | Re: [Amps] every db lost re Tubes vs. Solid State, Larry Benko |
Previous by Thread: | Re: [Amps] every db lost re Tubes vs. Solid State, Larry Benko |
Next by Thread: | Re: [Amps] every db lost re Tubes vs. Solid State, Larry Benko |
Indexes: | [Date] [Thread] [Top] [All Lists] |