I picked up a case of that small stuff for $20 when my last company switched
to the garbage grade; sold off quite a bit at sometimes close to that total
per roll. It takes a long time to go thru a roll for SS discrete to SMD
work.
Its the large thicknesses I use for amps and boatanchors and I grab that
whenever I can find a bargain.along with the old variety of silver content.
The modern stuff isnt even good for copper pipes!
Carl
KM1H
----- Original Message -----
From: "Ron Youvan" <ka4inm@gmail.com>
To: "amps" <amps@contesting.com>
Sent: Wednesday, August 29, 2012 9:19 AM
Subject: Re: [Amps] current threads about silver solder and resoldering
> Don W4DNR donroden@hiwaay.net wrote:
>
>> I have several rolls of 63/37 that I hoarded before POS ....er ROH
>
> I bought a new roll (1 lb) of my favorite, Ersin multicore solder
> (very thin .022" = .55 mm, type SN63 made in the USA ???) sealed in
> shrink wrap for $7 at the Orlando HAMfest last February, I will be
> looking to buy more in different sizes at every HAMfest I visit for the
> next few years.
> --
> Ron - KA4INM
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2437/5232 - Release Date: 08/29/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|