Amps
[Top] [All Lists]

Re: [Amps] Relay Timing Measurements

To: Amps <amps@contesting.com>
Subject: Re: [Amps] Relay Timing Measurements
From: Bill Turner <dezrat1242@yahoo.com>
Date: Fri, 14 Dec 2012 13:47:19 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
ORIGINAL MESSAGE: 
On Thu, 13 Dec 2012 10:20:54 -0700, Jim wrote:

>
>Now that I think about it, I think I am wrong. I'm thinking of a "dual beam"
>scope, which has two cathodes.  Now I hold the opinion that a "dual trace"
>scope is the same thing as a "dual channel" scope. Of course, I could be
>wrong about that too.

REPLY: 
No, you are correct. Dual beam scopes are very rare, in fact in 50
years in the electronics biz and ten years working at Tektronix I have
never seen one. Dual trace scopes, on the other had, are quite common.

73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>