Amps
[Top] [All Lists]

Re: [Amps] Vacuum Relay

To: Amps <amps@contesting.com>
Subject: Re: [Amps] Vacuum Relay
From: Bill Turner <dezrat1242@yahoo.com>
Date: Fri, 14 Dec 2012 13:42:13 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
ORIGINAL MESSAGE: 
On Thu, 13 Dec 2012 14:15:57 -0500, W9AC wrote:

>The dual trace function isn't required to determine if hot-switching occurs, 
>but is required to measure system timing.  For station monitoring here, the 
>scope's Channel A is set to trigger on the keyer's output while Channel B 
>samples RF. 

REPLY: 
A dual trace scope is NOT required for this measurement. A single
trace scope which has an external trigger input (most do) will do the
job just fine. 

In the above scenario Paul is using channel A to do the triggering,
but triggering can also be done by the external trigger input. 

73, Bill W6WRT
ex-Tektronix Production Supervisor and Calibration Technician,
Portable Scopes Division 1977-1986
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>