Thanks guys for the input.
I looked at the switch and it didn't have any obvious problems but I figured
a better inspection is required.
Disconnecting the transformer leads was on my list as well. A new
transformer is about $300 unless I can find a used one that still works. It
also looks like a bear to get out.
The filter caps are only a couple years old which doesn't guarantee that
they are still good of course. I had a Henry 1KD5 years ago that blew a cap
within a year. A bit more spectacular than this one. The Henry arced through
a 0.25 inch phenolic board among other things and didn't blow a fuse!
Since I had replaced the power supply board I thought maybe there was a wire
I didn't get on correctly and when I turned the switch it finally moved
enough to short or arc. I didn't see any obvious arc sites or wires out of
place which is why I sacrificed another fuse.
-----Original Message-----
From: Carl
Sent: Wednesday, September 11, 2013 2:58 PM
To: Larry ; amps@contesting.com
Subject: Re: [Amps] Clipperton-L question
Id check the SSB/CW switch carefully for arcing to a metal part. Common
problem with an underated switch.
Carl
KM1H
----- Original Message -----
From: "Larry" <lknain@nc.rr.com>
To: <amps@contesting.com>
Sent: Wednesday, September 11, 2013 2:43 PM
Subject: [Amps] Clipperton-L question
One day when I switched from CW to SSB mode on my Clipperton-L it blew the
fuse with a good bang. The switch picks between a tap and one side of the
power transformer secondary – tap being for CW. I forget but for SSB I
think the power supply supplies 2500V(+/-) and somewhere around 2000V(+/-)
for CW. Nothing obviously wrong that I could see with just the covers
off. I replaced the fuse and as soon as I turned the amp on it blew the
fuse again. I searched the web to see if someone had seen this problem
before and had written about it but I didn’t find anything. I have had
the amp since it was new (1984?) but I put a Harbach power supply board in
it about 2 years ago. As a long shot I thought I might ask here if anyone
had seen a similar problem before I try to troubleshoot this.
73, Larry W6NWS
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1432 / Virus Database: 3222/6155 - Release Date: 09/11/13
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|