On 09/11/2013 02:58 PM, Carl wrote:
Id check the SSB/CW switch carefully for arcing to a metal part. Common
problem with an underrated switch.
"Larry" <lknain@nc.rr.com> wrote:
One day when I switched from CW to SSB mode on my Clipperton-L it blew
the fuse with a good bang. The switch picks between a tap and one side
of the power transformer secondary – tap being for CW.
I would take the switch out and put a "wire nut" on one transformer
connection sealing it off and make the other connection with another
"wire nut" and test. Then I would switch to the other transformer
connection and test, if both work the switch is arcing.
--
Ron KA4INM - Youvan's corollary:
Every action results in unwanted side effects.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|