Manipulating the 15M coil should have little effect on 20M and none that
will be noticable on the other bands. In all cases the full tuning ranges
should be fine.
If it is way off then moving a tap is needed. What I dont understand is "I
was thinking of squeezing or spreading the coil turns on the 21MHz inductor
closest to the tube"
Do you have more than one 21MHz inductor?
Carl
KM1H
----- Original Message -----
From: "Glen Zook" <gzook@yahoo.com>
To: "Dave Hachadorian" <k6ll.dave@gmail.com>; <amps@contesting.com>
Sent: Friday, October 04, 2013 8:40 PM
Subject: Re: [Amps] Tune cap at minimum
To lower the inductance, the turns need to be farther apart. However, that
will affect the other bands as well. It would be better to move the 15-meter
tap so that less turns are selected. I would start with 1-turn less.
Glen, K9STH
Website: http://k9sth.com
________________________________
From: Dave Hachadorian <k6ll.dave@gmail.com>
To: amps@contesting.com
Sent: Thursday, October 3, 2013 12:17 PM
Subject: [Amps] Tune cap at minimum
I have an amplifier that tunes up on 21 MHz with the tune
capacitor at minimum value. It acts like the capacitance should
be even lower for max efficiency and output on 21 MHz. All of
the other bands, 10 through 160 are fine. The output network is
a pi-L, and the tubes are a pair of GU-74b's.
I was thinking of squeezing or spreading the coil turns on the 21
MHz inductor closest to the tube, but I can't find the dang
formulas to figure out which way to go.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1432 / Virus Database: 3222/6224 - Release Date: 10/04/13
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|