Date: Fri, 4 Oct 2013 17:40:31 -0700 (PDT)
From: Glen Zook <gzook@yahoo.com>
To: Dave Hachadorian <k6ll.dave@gmail.com>, "amps@contesting.com"
<amps@contesting.com>
Subject: Re: [Amps] Tune cap at minimum
To lower the inductance, the turns need to be farther apart. ?However, that
will affect the other bands as well. ?It would be better to move the 15-meter
tap so that less turns are selected. ?I would start with 1-turn less.
?
Glen, K9STH
## 1 turn is probably way too much. Try just one quarter of a turn. You are
correct though. If you spread the coil further apart, you will lower the uh on
160-20m as well. 160-30 m is no big deal, but
it will cause an increase in loaded Q on 20m. Trying to shift a tap just a
quarter or half a turn is not always easy some times. But it can be
done...use longer cu strap for the tap....and if its also wider, you wont
get any increase in uh caused by the tap.
Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|