Vic,
Seriously, I'd be surprised if anybody actually would know except by experience!
As the old saying goes (admittedly capable of mis-interpretation in the USA!)
'Suck it and see!'
73
Peter G3RZP
========================================
Message Received: Oct 22 2013, 11:38 PM
From: "Vic K2VCO" <k2vco.vic@gmail.com>
To: "Amps reflector" <amps@contesting.com>
Cc:
Subject: [Amps] Screen regulation
For reasons that I won't go into, I want to put a 22 ohm resistor between a
regulated supply and the screen of a 4CX1000A. This would upset the
regulation to the tune of 0.77 volts when the screen current swings between
0 and 35 mA. Without the resistor, the regulator holds the screen voltage
constant within 0.1 volt from 0 to 35 mA.
From the standpoint of linearity/IMD would this be a problem?
--
Vic, K2VCO
Fresno CA
[1]http://www.qsl.net/k2vco/
References
1. http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|