Only if you want it to be a problem and can split hairs on the SA.
Carl
KM1H
----- Original Message -----
From: "Vic K2VCO" <k2vco.vic@gmail.com>
To: "Amps reflector" <amps@contesting.com>
Sent: Tuesday, October 22, 2013 6:18 PM
Subject: [Amps] Screen regulation
For reasons that I won't go into, I want to put a 22 ohm resistor
between a
regulated supply and the screen of a 4CX1000A. This would upset the
regulation to the tune of 0.77 volts when the screen current swings
between
0 and 35 mA. Without the resistor, the regulator holds the screen
voltage
constant within 0.1 volt from 0 to 35 mA.
From the standpoint of linearity/IMD would this be a problem?
--
Vic, K2VCO
Fresno CA
[1]http://www.qsl.net/k2vco/
References
1. http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1432 / Virus Database: 3222/6272 - Release Date: 10/22/13
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|