Just FYI, from Wikipedia:
MHV connectors are presently considered by some as a safety hazard because of
the possibility of high voltage on the exposed central pin when not plugged
in,[1] and because the ground connection is broken before the power connection
when demating. SHV connectors are designed to prevent these hazards, and cannot
be mated to BNC connectors.
Always have liked the idea of separate power supplies but have always worried
about the safety of interconnects. The one other person I know who did this
did not use any connectors for the HV. Accomplished the goal decoupling the
supply from the amp, but requires tools and time to move either chassis more
than the length of the umbilical away from each other.
Al
AB2ZY
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Vic K2VCO
Sent: Sunday, October 27, 2013 11:03 PM
To: Amps reflector
Subject: [Amps] 4CX1000A project
I've added a few more photos to my 4CX1000A amplifier page at
<http://www.qsl.net/k2vco/4CX1000A/K2VCO%204CX1000A%20Amplifier.html>
I finished the wiring as well as testing and adjusting the Tetrode Boards,
which include the screen and bias regulators and trip circuits, the warmup
timer, etc. I have not yet applied HV, which I intend to do when I'm fresh, and
after I've cooked the tube with heater voltage only for a while.
I'm working on adding fans to a '1000 watt' Drake dummy load to use for testing.
--
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|