I believe the standard US angle is 82 degrees for non aircraft use. Metric
is 100*
Carl
KM1H
----- Original Message -----
From: "KA4INM radio" <ka4inm@gmail.com>
To: "amps" <amps@contesting.com>
Sent: Thursday, December 04, 2014 9:26 PM
Subject: Re: [Amps] Alpha 76 case screws
On 12/04/14 20:39, Charlie K1XX Carroll wrote:
Does anyone know the type of screw used in the sides of the Alpha 76?
It's a 6-32, stainless with some sort of a flat head . RF Concepts
doesn't have a clue. I have a picture if someone can help ID it.
In America "flat headed" machine screws go in a countersunk hole,
while in England countersunk headed" machine screws go in a countersunk
hole. "Flat headed" machine screws are commonly made with one of three
countersunk angles.
Very flattened pan headed like machine screws are commonly called
"flat headed" machine screws.
I would recommended looking over the selection at:
http://www.mcmaster.com/#screws/=uvu7hh
and see if the proper named can be discovered.
--
Ron KA4INM - Youvan's corollary:
Every action results in unwanted side effects.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.5577 / Virus Database: 4235/8685 - Release Date: 12/05/14
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|