If that's the case, it would need to be a really bad switch since only 1 mA
passes through it and the meter. More likely a multiplier resistor that
drifted high.
-WB2WIK
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of qrv@kd4e.com
Sent: Friday, January 23, 2015 3:48 PM
To: Amplifier Mailing List
Subject: Re: [Amps] 5 Minutes for Ameritron 811H to warm up?
The seller just wrote this:
"I think the problem is in the meter circuit. Even when the meter shows just
800 volt the amp does 600 watts. We were checking it out today and I don't
think it needs caps, it might just be the multimeter switch is dirty or bad."
--
*David*
~KD4E~
Nevils, Georgia USA
Safe & Secure Search Engine: duckduckgo.com
Android for Hams: groups.yahoo.com/group/hamdroid Creative Tech:
groups.yahoo.com/group/ham-macguyver
Raspi Alternative: groups.yahoo.com/group/beagleboneblack/
Restored to design-spec at Heaven's gate 1Cor15:22
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|