Gary,
I would replace the bulbs with LEDs. I've done that in both my AL-811H
and my tuner with a dropping resister and the new bright white LEDs and
I"ll probably never have to touch them again.
--
Thanks,
Gary Schweitzer
KF7BS | KF7BS@comcast.net <mailto:KF7BS@comcast.net>
--
On 1/27/15 10:43 PM, Gary Smith wrote:
I have two Astron power supplies; a VS-35M & a RS-35M. The RS-35M has
stopped working & I have to track down that issue. While I'm in
there, are there any known mods I should do to either of these?
Sounds like I should remove the paint under the lug and attach the
green wire properly to the chassis.
Anything else that's suggested?
An aside, the lamps in these meters are terrible, both of these
supplies are fairly new and all four of the meter lamps are dead and
absolute buggers to get at. Several calls to the company were met
with indifference and no replacement lamps.
If there's known mods, I'm always keen on upgrading my station.
73,
Gary
KA1J
On Tue,1/27/2015 4:08 PM, Tom W8JI wrote:
The flaw in this system is that differential voltages between current
carrying wires are not measured, and anything on the safety ground
isn't measured. Noise voltage is only measured from individual
current carrying conductors to ground, and the safety ground is
grounded and not measured.
Exactly right, Tom. A common design/manufacturing defect is that the
green wire fails to make contact with the shielding enclosure, but
instead goes to common on a circuit board, which may or may not ever
find the chassis. This defect, which is the power system equivalent of a
Pin One Problem, puts noise on the green wire. You may remember that we
corresponded several years ago about Astron power supplies, in which a
very common defect is that the green wire is soldered to the mounting
lug of a terminal strip, which is insulated from the chassis by paint.
The same mounting lug is the point where V- is bonded, so it never finds
the chassis either. AND, wiring for both V- and the green wire act as
antennas for both TX and RX.
I have long suspected that similar defects are at least partially
responsible for noise conducted onto coax and AC lines from consumer
products of all sorts.
73, Jim K9YC
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|