Amps
[Top] [All Lists]

Re: [Amps] Biasing a Class C modulated final

To: "Roger \(K8RI\)" <k8ri@rogerhalstead.com>, <amps@contesting.com>
Subject: Re: [Amps] Biasing a Class C modulated final
From: "Carl" <km1h@jeremy.qozzy.com>
Date: Wed, 18 Feb 2015 10:01:20 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
The original 6L6, which is metal, is not highly prized by the audiophools. The 2E26 is a reduced power choice and goes for pennies. Another interesting and cute choice is the 815.

One way around the clamp tube is to select a tube that runs at a reduced voltage so that when there is no bias the plate dissipation is low. A problem with the clamp tube is as it ages the threshold needs to be readjusted, a real pain in the DX-100 and other rigs of the era where the 6AQ5 is being run pretty hard.

One tube that is often overlooked and can be found NIB for around $20 or less is the 4D32 which was used in the Collins 32V series, Johnson Viking I, and Hallicrafters HT-20. The 3E29, 829B, 5894 family are close equivalents when sections are run in parallel.

Carl
KM1H


----- Original Message ----- From: "Roger (K8RI)" <k8ri@rogerhalstead.com>
To: <amps@contesting.com>
Sent: Tuesday, February 17, 2015 9:13 PM
Subject: Re: [Amps] Biasing a Class C modulated final


Not sure the 6L6 would be a good choice due to price, unless you have some, or a good source. The price on them is astronomical. My guitar amp uses 6 of them. I could purchase a nice, new amp for less than replacing those tubes.

 73

Roger (K8RI)

On 2/17/2015 5:14 PM, KA4INM wrote:
  On 02/17/2015 03:11 PM, Paul KW7Y Baldock wrote:

I am building a 2x813 class C final modulated by 2x813.

The typical way to bias the class C final is with a combination of fixed
bias applied to the control grid and bias derived from the rf drive
through a grid resistor.

Rather than fixed bias applied to the grid it seems that I could achieve
the same effect by using a pseudo zener in series with the cathode,
similar to what is used in cathode driven linears.

Any thoughts on this approach?

I am guessing common cathode RF amplifier, a more standard way to do it would be an adjustable bias supply and a clamp tube on the screen grid. (6L6 or similar) look into any pre-1960 ARRL hand book.


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.5645 / Virus Database: 4284/9134 - Release Date: 02/17/15


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>