Re: [Amps] GS35B Gassy, or Arcing?

[nemo zilch <nemozilch@gmail.com>]

Thanks Mike.  Yes I did the online research first and followed what seemed
to be the best advice.  Brought the filament up to full voltage very slowly
in small steps, then let it run for a week and a half at full filament
power, no plate voltage.

I am doing the hi pot test with cold filament, grid grounded and positive
voltage on the plate.

Bob W4AOS


-- 
==========================================================
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps