Amps
[Top] [All Lists]

Re: [Amps] Ferrite Core for 160M PI Output ?

To: "'Peter Voelpel'" <dj7ww@t-online.de>, "'Chris Wilson'" <chris@chriswilson.tv>, <amps@contesting.com>
Subject: Re: [Amps] Ferrite Core for 160M PI Output ?
From: "JC" <n4is@comcast.net>
Date: Tue, 13 Jun 2017 12:10:33 -0400
List-post: <mailto:amps@contesting.com>
Hi Peter

PI network loss is related with the Q of the inductor, you need material #2
or #6 ( better stability with temperature), #61 #77 are good for BALUN or
chokes and not good for inductors with high Q.

73
N4IS
JC 

-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Peter Voelpel
Sent: Tuesday, June 13, 2017 11:28 AM
To: 'Chris Wilson' <chris@chriswilson.tv>; amps@contesting.com
Subject: Re: [Amps] Ferrite Core for 160M PI Output ?

Hi Chris,

The builder and owner of the amp is sk, so I don´t know if the amp is still
in use.
But when he built it we where in close contact and I suggested the cores to
him.
The material is close to mix 61, their diameter is 120mm and the thickness
is 15mm, he used a stack of three.
The tape wrapping is only necessary to break the very sharp edges of the
cores, they are not as smooth as the Fire-Rite cores.
Electrically it is not necessary, the do not conduct.

The cores are from ex GDR military sources which more or less dried out.
Dirt cheap they were sold on flea markets for 1,-DM each at the beginning.
The last 50 I bought in 2005 were 2.50 Euro each.
 
73
Peter



-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Chris Wilson


Hello Peter,

Thanks  for  the photos of the LF tube amp, is there any more info on it
available anywhere? My friend speaks fluent German if it's in that language.

Just  how  conductive *IS* ferrite anyway, i have never probed it. And how
much  of an adavatage is there in stcking cores which are totally flat  on
the  sides which mate together when stacked compared to some that  have  a
bevelled (radiused) surface? i have some FT240-78 cores that all came from
FairRite but some are flat, some bevelled....


Thanks.


On Tuesday, June 13, 2017,  you wrote:

> When I use multiple cores I glue them together with two component 
> epoxy first and then I insulate and wind them, much easier.

> 73
> Peter





--
Best regards,
 Chris                            mailto:chris@chriswilson.tv

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


---
Diese E-Mail wurde von Avast Antivirus-Software auf Viren geprüft.
https://www.avast.com/antivirus

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>