I should have added that I am using EZNEC+ V5
73,
Dave
This question is a long shot, but knowing the resourcefulness of the
group I thought I would ask anyway..
I am doing some comparisons of various receive antennas, some of
which have very different gains. I am overlaying different plot
files to compare the patterns, especially the pattern off the back.
This has been quite difficult on occasions because of the big gain differences.
I wondered if there was a way to "normalise" the gain of two plots
so as to be able to get an easier comparison? Another way of saying
it would be to able to make the gain of the outer rings of two plots identical?
Is it possible or are there any other techniques to simplify the comparisons?
Thanks for any ideas.
73,
Dave, G3UEG
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware
|