Dave,
EZNEC does this automatically if you recall a saved trace and add it to the
current trace. If you are overlaying exported bitmap files in a graphics
program, choose a fixed outer ring value in the 'Desc Options' setup.
Gary
K9AY
>I should have added that I am using EZNEC+ V5
>
> 73,
> Dave
>
>
>
>
> This question is a long shot, but knowing the resourcefulness of the
> group I thought I would ask anyway..
>
> I am doing some comparisons of various receive antennas, some of
> which have very different gains. I am overlaying different plot
> files to compare the patterns, especially the pattern off the back.
> This has been quite difficult on occasions because of the big gain
> differences.
>
> I wondered if there was a way to "normalise" the gain of two plots
> so as to be able to get an easier comparison? Another way of saying
> it would be to able to make the gain of the outer rings of two plots
> identical?
>
> Is it possible or are there any other techniques to simplify the
> comparisons?
>
> Thanks for any ideas.
>
> 73,
> Dave, G3UEG
>
> _______________________________________________
> Antennaware mailing list
> Antennaware@contesting.com
> http://lists.contesting.com/mailman/listinfo/antennaware
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware
|