>**************
>Nicopress fittings are available from many other companies (such as Indusco
>and Newco) in both copper and aluminum. (The little aluminum ovals that are
>crimped onto the cable on winches.) These were designed for use on aircraft
>cable.....
> <snip>
>Their conclusion
>was that 3 were required on 1x7 to guarantee that the fittings were stronger
>than the cable. Of course use of the proper tool is also required--I have
>heard of people "setting" them with a hammer--shudder. The tool for the
>fittings for 1/4 cable gets pretty expensive, especially if you are only
>going to do a few. (Think I paid quite a bit over a hundred bucks in the
>70s for mine.) And you need to do the proper number of crimps for the
>fitting you are using, of course.
>
Funny you should mention this. A few years ago I was replacing the cables
on my crankup and faced a choice. Either use cables clamps (which can
occasionally clank against tower rungs as the tower is lower/raised) or
figure out how to get those snazzy fittings like the factory does. Out of
curiosity, I brought one of the cables to Home Depot, found the fittings,
and then asked the salesman "How do I smush these things?". He promptly
spun around, grabbed a box off the highest shelf, and handed me the tool.
About $65 if I remember correctly, and it handles about 6 different sizes
of fittings, which should cover most ham needs. Quite nifty, and gives a
more secure and professional looking appearance to your cables.
73, John - WB2K
------------------------------------------------------------------
John A. Ross, IV - WB2K / VE2TJA [Zone 2] (wb2k@ritz.mordor.com)
Summit, New Jersey
Contest DXpedition Registry ---------> http://www.mordor.com/wb2k
------------------------------------------------------------------
|