CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] SO2R audio spike problem

To: "Barkey, Patrick M." <pbarkey@bsu.edu>,<cq-contest@contesting.com>
Subject: Re: [CQ-Contest] SO2R audio spike problem
From: "David A. Pruett" <k8cc@comcast.net>
Date: Fri, 06 Feb 2004 18:09:07 -0500
List-post: <mailto:cq-contest@contesting.com>
Pat,

I wonder if this has something to do with the fact that ICOMs have +8V on the mic pin of the radio for use with electret mics? This voltage is not required for non-electret elements such as the Heil (either DX or standard), and indeed should be blocked with a capacitor of 0.22uF or greater.

The Heil ICOM adapter (from sub-mini jack to 8-pin plug) has the blocking capacitor built in. If you've built the two-radio switch box just like the schematic, and you're plugging the Heil in directly, your mic is seeing +8VDC on it. The "pop" you're hearing on switching may be caused when the mic connects, and loads down the +8V supply.

If one isn't present already, I would add a blocking capacitor at the jack where your Heil plugs into the switchbox. This will block the +8VDC from getting both to the headset and the DVP. The latter probably doesn't need the protection, as I'm pretty sure it's capacitively coupled.

The cap value is non-critical - anything over .22uF and rated for 8VDC or more is OK. An electrolytic is OK too - I would put the + end towards the radio.

73,

Dave/K8CC


At 03:06 PM 2/6/04 -0500, Barkey, Patrick M. wrote:
I've been running a pair of IC-765's with a N6TR-style
two radio switch box for quite some time.  This is the
one described in http://www.kkn.net/~k5tr/trlog/switch.pdf

I have noticed on SSB for some time that whenever I
switch between radios, the VOX on the radio I am
switching towards pops.  I have a very short delay, so
this is not a big deal.

The problem is this.  Many times after switching my mike
to radio #2 to work a multiplier, and then back to radio #1
to call CQ, I loose audio output from my microphone
and my DVP entirely.  It will be dead for about 5-10 seconds.

If I leave the VOX off on both radios, this never happens.
But I like to use VOX, so this isn't a great solution.

I am using a Heil Pro-Set mike with a DX element.

Anybody got any suggestions for a solution? Thanks.

  - Pat
    N9RV

---------------------------------------------------------------
    The world's top contesters battle it out in Finland!
THE OFFICIAL FILM of WRTC 2002 now on professional DVD and VHS!
       http://home1.pacific.net.sg/~jamesb/
---------------------------------------------------------------

_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest


---------------------------------------------------------------
   The world's top contesters battle it out in Finland!
THE OFFICIAL FILM of WRTC 2002 now on professional DVD and VHS!
      http://home1.pacific.net.sg/~jamesb/
---------------------------------------------------------------

_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

<Prev in Thread] Current Thread [Next in Thread>