Ron
For RTTY the Ft-1000 MP is very easy,
If you have the computer with Serial Com Port can be cheap and easy to
transmit FSK with the MMTTY
NCJ a few months ago show the interface you need , but RTTYCONTESTING.COM
also have it, a pair of 2n2222 transitors
a pair of resistors and some work and you are done
Also when you be ready to start transmit check your MENU and make the change
in the RTTY POLARITY because the radio say Normal but
is not correct , change to reverse and you will be in the same RX and TX.
Also you can buy this interface http://www.w3yy.com/fsk.htm is a fair price
and also show all the wiring
Good luck and welcome to the RTTY Fun
J. Hector Garcia XE2K / AD6D
Mexicali B.C DM22fp
P.O.Box 73
El Centro CA 92244-0073
USA
http://www.xe2k.net
http://www.dxxe.org
________________________________
From: KU7Y <ku7y.cw@gmail.com>
To: cq-contest@contesting.com
Sent: Wed, May 19, 2010 8:26:07 PM
Subject: Re: [CQ-Contest] RTTY Contests
Hi All,
I would like to try some RTTY contesting this winter. The rig is an FT-1000
MP.
What is the best way to connect to the computer?
I have a RIGblaster pro that I have never used. Is this a good way to go?
If so, are there any issues I need to watch for with the MP?
Thanks,
OK, back in my hole,
Ron, KU7Y
SOWP 5545M
Caldwell, ID
ku7y@qsl.net
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|