CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] two radios on same band (10m contest)

To: "'Kevin McGrath'" <kj_mcgrath@yahoo.com>, <cq-contest@contesting.com>
Subject: Re: [CQ-Contest] two radios on same band (10m contest)
From: "Rex Maner" <k7qq@netzero.net>
Date: Thu, 28 Nov 2013 17:12:38 -0000
List-post: <cq-contest@contesting.com">mailto:cq-contest@contesting.com>
In the early 70's  K7JA and myself W5QQQ operated at W7RM, we started on 15 ssb 
working JA's and the Caribbean, Chip was running well over 200 Q's per hour and 
I was S & P . 

At this particular time there was no restriction on how many signals could be 
on the band at the same time. 

We were both running Collins S-Line and KW's.

The antennas had aprox 250 foot of vertical separation . The lower antenna was 
about 70 ft above saltwater beaming to Asia and antenna # 2 was at 170 foot 
beaming east.  

We were able to, with ease operate within 15Khz and not even know the other 
station was on the band. We had no filters .

Rex K7QQ
  

-----Original Message-----
From: CQ-Contest [mailto:cq-contest-bounces@contesting.com] On Behalf Of Kevin 
McGrath
Sent: Thursday, November 28, 2013 2:55 AM
To: cq-contest@contesting.com
Subject: [CQ-Contest] two radios on same band (10m contest)

I would like to get some advice on running two radios on the
*same* band, specifically for 10 meters.There’s plenty of good information here 
and on the web regarding minimizing interference when running multiple radios 
on different bands, but not much info at all on the same band.

The plan is to enter the ARRL10m contest, multi-op, mixed SSB/CW, low-power 
(<150 watt) category and use a run radio and a multiplier radio (only one 
transmitter at a time).  To help minimize interference, one radio would be on 
CW portion (say below 28.050) and the other on SSB (above 28.400) and thus 
maintain at least a 350-400kHz frequency separation. Also the antennas for each 
radio will be different polarizations. But given space limitations at the QTH, 
the antennas can only be separated by 100’.   Are commercial bandpass filters 
or homebrew designs available for in-band use? 


 I’m guessing two
radios have been successfully used for the 10m contest. Any ideas or tips on 
the setup for minimizing inter-station interference would be greatly 
appreciated.
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

____________________________________________________________
Stand Up To Cancer
The Solution Is Finally Within Our Reach - Donate Now 
http://thirdpartyoffers.netzero.net/TGL3265/52975c56f29145c5472d2mp12vuc

_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
<Prev in Thread] Current Thread [Next in Thread>