FB Dennis.....the BandMap works flawlessly with ONE radio, but with a
TWO radio set up, the BandMap for RADIO2 does NOT work.
In our network, the BandMap works perfectly at each position, except
where there are TWO radios at a given position.
That was my question.....has anyone had trouble (or know of a fix) for
the BandMap for the RADIO2? (Single-op, two radio operation).
73! Glenn W0GJ
NB1B@aol.com wrote:
>
> At K1XM MM we used CT 9.39 with no problems at all. The only computer reboots
> that I can recall where to take care of RFI problems- CT and our Ethernet
> network performed flawlessly.
>
> I see that a number of people are having problems with the band map. I did
> have a problem with it, but that was solved by reading the manual. To help
> those use it, I went over how to use the Announce Window and then how to use
> the Band Map.
>
> Announce Window:
> 1. <Alt A> toggles the announce window.
> 2. <Ctrl Rt Arrow> puts you into the window to select a spot.
> 3. <Up/Down Arrows> lets you select your spot.
> 4. <Enter> then puts the spot into the logging line.
> 5. <ESC> at any time gets you out of the window and back to the logging line.
>
> Band Map
> 1. <Alt ,> toggles the Band Map Window.
> 2. <Alt Rt Arrow> puts you into the window to select a spot.
> 3. <Up/Down Arrow> lets you select an entry in the window.
> 4. <Enter> puts your selection onto the logging line.
> 5. <ESC> at any time gets you out of the window and back to the logging line.
>
> If I use the Band map as above (and notice the correlation with how the
> Announce Window is used), it has worked correctly every time. If I bring up
> the Band Map by using <Alt Rt Arrow> without using the <Alt ,> I have found
> that I have problems, i.e. the <Enter> key stops functioning. I have also
> found that if I enter the band map, there usually won't be a station where the
> radio frequency is, i.e. the red band has no callsign in it. If I press the
> <Enter> key without selecting a station, I will get garbage on the logging
> line. To recap, display the window, enter the window, select the station,
> then either use <Enter> to put it on the logging line or <ESC> to get out of
> the window. Hope everyone had a ball this past weekend.
>
> Dennis NB1B
>
> --
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.contesting.com/ct/
> Questions: owner-ct-user@contesting.com
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|