That would be an IBM question - not a CT question.
----- Original Message -----
From: "alsopb" <alsopb@gloryroad.net>
To: <ct-user@contesting.com>
Sent: Monday, July 01, 2002 10:25 AM
Subject: Re: [ct-user] CTDOS/Windows98
> I think the replies to this missed the issue.
>
> On my Thinkpad with WIN98 when one boots to DOS, the entire DOS screen
> occupies a block in the center of the screen. I want DOS to occupy
> the entire screen just like it does on a normal monitor. It
> apparently is putting the 640x200 DOS screen in the center of the
> 1024x768 SVGA display.
>
> de Brian/K3KO
>
> Hank Kohl K8DD wrote:
> >
> > At 7/1/02 10:15 AM +0100, Buffham, Ian wrote:
> > >I have a DOS version of CT which works just fine under Windows 95. I
have
> > >just acquired a laptop for use in a contest which has Windows 98. CT
runs
> > >OK with this but the problem is that the display only occupies about
one
> > >third of the screen. Does any one have any ideas as how to make it
occupy
> > >the full screen?
> > >Regards Ian G3TMA (Also G3TMA@aol.com)
> >
> > From a DOS window, press ALT-Enter for full screen mode.
> > Although I'd run it from a Command Prompt (DOS Mode- press F8 during
boot).
> >
> > 73 Hank
> >
> > _______________________________________________
> > ct-user mailing list
> > ct-user@contesting.com
> > ct-user-request@contesting.com Subject=unsubscribe to unsubscribe
> > http://lists.contesting.com/mailman/listinfo/ct-user
> _______________________________________________
> ct-user mailing list
> ct-user@contesting.com
> ct-user-request@contesting.com Subject=unsubscribe to unsubscribe
> http://lists.contesting.com/mailman/listinfo/ct-user
|