The Border Router must know where all your internal networks are or what the
next hop to them is.
Each additional router must know where the other networks are at, or know
somebody (another router) that knows where all the networks are at.....make
sense?
Example: 3 networks (each a class C to make it easy)
Border Router
|
|
=================
| |
AP1 AP2
We will say that the 10.1.1.x subnet is for our AP's and servers (class C,
subnet mask: 255.255.255.0)
Each AP will have an interface on the AP subnet and an interface on a client
network. The AP will route between them.
Border Router (just for the fun of it, does NAT)
External: 205.1.1.12 (made this up..not really signifigant)
IP: 10.1.1.1
Mask: 255.255.255.0
Needs Route = 10.1.2.0 255.255.255.0 -> 10.1.1.2
Needs Route = 10.1.3.0 255.255.255.0 -> 10.1.1.3
AP1
Default Gateway = 10.1.1.1
Wlan1: 10.1.1.2
Mask: 255.255.255.0
<cleint network>
Wlan2: 10.1.2.1
Mask: 255.255.255.0
Needs Direct Route = 10.1.2.1 255.255.255.0 wlan2
AP2
Default Gateway = 10.1.1.1
Wlan1: 10.1.1.3
Mask: 255.255.255.0
<cleint network>
Wlan2: 10.1.3.1
Mask: 255.255.255.0
Needs Direct Route = 10.1.3.1 255.255.255.0 wlan2
-Bob
----- Original Message -----
From: "Bill Fisher" <fisher@akorn.net>
To: <karlnet@WISPNotes.com>
Sent: Friday, April 26, 2002 11:48 AM
Subject: [Karlnet] Karlnet Routing
>
> Charles has been trying to get this routing stuff through my thick head,
and
> so far all I can do is make bridging work. Maybe someone else can jump in
> with some advice?
>
> Here is my set up:
>
> http://www.wispnotes.com/pdf/AkornWirelessRouting.pdf - Ignore router
setup
> box bottom right.
>
> My internal network is almost all 216.1.128.0/24.
>
> I have 216.1.129.128/25 setup in the border router to route to
216.1.128.91,
> the Teletronics box.
>
> Can someone give me a scenario where the 2 AP-1000's at the remote tower
> will route and work on my internal network? I have gotten as far as them
> working outside the border router, but not inside.
>
> Does the remote AP-1000 that forms the link need to have bridging and
> routing turned on? That is what I have been using.
>
> Thanks!
>
> Bill
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|