oops... sent it too fast..
https://gullfoss2.fcc.gov/cgi-bin/ws.exe/prod/oet/forms/reports/Search_Form.
hts?mode=Edit&form=Exhibits&application_id=251127&fcc_id=NI3-2511CD-PLUS2
> http://www.fcc.gov/oet/fccid/
>
> > No, I haven't--but I will. Is there a url that I can go to to check?
> >
> > As nearly as I can tell (the type is a little small): FCC ID:
> > NI3-2511CD-PLUS2.
> >
> > -----Original Message-----
> > From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> > On Behalf Of Bob Hrbek
> > Sent: Friday, May 17, 2002 12:30 PM
> > To: karlnet@WISPNotes.com
> > Subject: Re: [Karlnet] higher power cards, what works, what doesn't
> >
> >
> > Have you looked up the FCC ID to see if it is actually valid?
> >
> > I checked mine...it was not.
> >
> > -Bob
> > ----- Original Message -----
> > From: "barrywhitcomb" <barrywhitcomb@msn.com>
> > To: <karlnet@WISPNotes.com>
> > Sent: Friday, May 17, 2002 11:24 AM
> > Subject: RE: [Karlnet] higher power cards, what works, what doesn't
> >
> >
> > > All Clear has been testing two 200 mW cards purchased from MikroTik at
> >
> > > our first tower--cell tower 300', Comet 12.4 dbi Omni antenna, YDI
> > > power amp is also on top (15 dbi gain))--we are running Turbocell ISB
> > > Base.
> > >
> > > We have been swapping an Orinoco with with Prism 200 mW in Turbocell
> > > base--both seem to run fine, the Prism does help signal but not
> > > substantially (since YDI power amp is installed to boost signal, and
> > > it will clip if overdriven).
> > >
> > > The Prism card noticably improves the equation on the CPE end. Earlier
> >
> > > in the week we tested the Orinoco and the Prism using the same
> > > antennas (8dbi Patch and 13 dbi Yagi). The Prism is working
> > > substantially better--stronger signal and better readings (especially
> > > with the 8 dbi patch).
> > >
> > > A lot of this signal measurement was in 802.11b mode (but not all).
> > > Some was in TC. I'll publish numbers soon.
> > >
> > > Bottom Line: We haven't seen any problems yet w/200 mW and they have
> > > an FCC number on the card. We intend to continue testing over the
> > > weekend.
> > >
> > > Barry Whitcomb
> > > Quantum Success, Inc. / All Clear
> > > 265 Paces Lakes Drive
> > > Dallas, GA 30157
> > > 770-505-1896
> > > F: 770-234-5334
> > >
> > > www.all-clear.biz (active 5/20/2002)
> > >
> > >
> > >
> > > -----Original Message-----
> > > From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
> > > On Behalf Of Norm Young
> > > Sent: Friday, May 17, 2002 12:00 PM
> > > To: karlnet@WISPNotes.com
> > > Subject: Re: [Karlnet] higher power cards, what works, what doesn't
> > >
> > >
> > > Dan, I'm using a PRISM II card I got from Tony (it's a Senao,
> > > http://www.senao-usa.com/SL-2011CDEXT.htm). Had some initial problems
> >
> > > with it in my PtMP (I think I may have some problems with connectors
> > > or with the antenna itself) side, but switched over to the PtP side (I
> >
> > > have an 18 mile
> > > backhaul) and it seems to be working quite well. (I'm surprised that
> > > reflected RF, if that is what it was, would cause the card to
> > > fruit-out like it did. Rx sensitivity went to hell, and there were
> > > problems doing remote reboots on the AP.)
> > >
> > > Norm
> > >
> > > ----- Original Message -----
> > > From: "Dan Metcalf" <danm@suncorstainless.com>
> > > To: <karlnet@WISPNotes.com>
> > > Sent: Friday, May 17, 2002 8:08 AM
> > > Subject: [Karlnet] higher power cards, what works, what doesn't
> > >
> > >
> > > > How many people out there are using the 100mw & 200mw cards w/
> > > > Karlnet
> > >
> > > > v4.02? what works what doesn't? I couldn't get the symbol24 card to
> > > > work. Also when you setup the rg1000 do you tell it what type of
> > card
> > > > is in the interface or do you leave it at default?
> > > >
> > > > Dan Metcalf
> > > > Wireless Broadband Systems
> > > > dan.metcalf@wbsysnet.com
> > > > 781-658-2075
> > > > www.wirelessbroadbandsystems.com
> > > >
> > > >
> > > > _______________________________________________
> > > > Karlnet mailing list
> > > > Karlnet@WISPNotes.com
> > > > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > > >
> > > >
> > >
> > > _______________________________________________
> > > Karlnet mailing list
> > > Karlnet@WISPNotes.com
> > > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > >
> > > _______________________________________________
> > > Karlnet mailing list
> > > Karlnet@WISPNotes.com
> > > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > >
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|